Xinxiang Shengda Filtration Technique Co., Ltd.

Oil Gas Separator,Oil Gas Separators,Oil And Gas Separator For Sale

Home > Products > Oil-Gas Separator > Compressor Filter > Compressor Oil-Gas Separator For Leybold

Compressor Oil-Gas Separator For Leybold

Basic Info

Model No.SD01100356

BrandShengda

Clapboardwithout Clapboard

Filter Number1

Medium MaterialFiberglass

Filtration GradeULPA Filter

TypeCartridge Filter

Additional Info

PackagingWooden Case

Productivity100 Thousands Annual

TransportationOcean,Land,Air

Place of OriginXinxiang

Supply Ability100 Thousands Annual

CertificateISO 9001, ISO 14001, ASME, OHS

HS Code8421299090

PortQingdao,Tianjin

Payment TypeT/T

IncotermFOB,CFR,CIF,FCA,CPT

Product Description

PN: SD01100356
Flow m³/min/0.7MPa: 10

Flange Diameter: 336

Height: 356



According to the design, the Oil-Gas Separator can be made of different layers. The first layer is usually a coalescence layer, which is made of borosilicate glass fibers with certain thickness and pore. The multi-layer sub-micron glass fibers ensure high efficiency of capturing small oil droplets of different lubricants at higher temperatures. The second layer is the separation layer. After coalescence, the large oil droplet flows through the separation layer into the bottom groove.


                                                                                                                              compressor filter

Installation:

Install sealing correctly and check whether there is a conductive measure;

Return pipe must be long enough and put straight into the filter, the end should be beveled, pay attention to check blockage;

Use high-quality Air Filter, Oil Filter and coolant and prevent generation of impurities in hydraulic system.



Troubleshooting

I. the high oil content of the exhaust.

1. Return line blockage.

2. Gaskets used improperly resulting in oil core short circuit.

3. Oil Separator tank design or selection unreasonable.

4. Oil barrel oil level is too high.

5. Compressor Low pressure operation, the displacement increases, reduced Separation Filter.

6. Operating temperature is too high, increase the amount of lubricating oil evaporation.

7. Use of substandard lubricants.






                                                                                                   compressor filter 1



Separation Efficiency

Under the rated flow rate and working pressure, outlet oil content: 0.1-3 mg/m³.


Note: The oil-gas separation filter can only achieve physical filtration, unable to capture the oil vapors in compressed gas; the above outlet oil content refers to the content of the non-gaseous oil aerosols. To get higher quality compressed air, after-filter is required.


Service life

Filter life consumption mainly shows in the form of the flow resistance increasing, so the service life is the primarily related to oil cleanness and filter properties. As long as the system is functioning properly, the service life can be up to 8000 hours(365 days no shut down), but no more than 10000 hours, the glass fiber falling down into the lubrication system causing secondary pollution should be prevented.



Flow Resistance

Flow resistance is an important indicator of filter performance. Under the premise of guaranteed filtration performance, lower flow resistance can reduce compressor energy consumption. Through several tests and improvement, the initial oil saturation pressure drop of oil-gas separation filter is within 16kpa, lower than the standard value 20kpa of peers.


Product Categories : Oil-Gas Separator > Compressor Filter

Product Images

  • Compressor Oil-Gas Separator For Leybold
Email to this supplier
  • *Subject:
  • *Messages:
    Your message must be between 20-8000 characters