Xinxiang Shengda Filtration Technique Co., Ltd.

Air Oil Separator For Air Compressor,Compressed Air Oil Removal,Compressed Gas Oil Filter

Home > Products > Oil-Gas Separator > Compressor Filter > Compressor Oil-Gas Separator For Comprag

Compressor Oil-Gas Separator For Comprag

Basic Info

Model No.SD01400470

Product Description

PN: SD01400470
Flow m³/min/0.7MPa: 40

Flange Diameter: 430

Height: 470



Depending on the applications, the gas Oil Separator can be constituted of different layers. The first layer is a coalesced layer which is made of fiberglass. Multi-layer sub-micron fiberglass ensures efficient capture of oil droplets at high temperature. The second layer is a separation layer, and the large oil droplet flows through the separation layer into the bottom tank.



                                                                                                                              compressor filter

Installation:

Install sealing correctly and check whether there is a conductive measure;

Return pipe must be long enough and put straight into the filter, the end should be beveled, pay attention to check blockage;

Use high-quality Air Filter, Oil Filter and coolant and prevent generation of impurities in hydraulic system.



Troubleshooting

I. the high oil content of the exhaust.

1. Return line blockage.

2. Gaskets used improperly resulting in oil core short circuit.

3. Oil separator tank design or selection unreasonable.

4. Oil barrel oil level is too high.

5. Compressor Low pressure operation, the displacement increases, reduced Separation Filter.

6. Operating temperature is too high, increase the amount of lubricating oil evaporation.

7. Use of substandard lubricants.






                                                                                                   compressor filter 1



Separation Efficiency

Under the rated flow rate and working pressure, outlet oil content: 0.1-3 mg/m³.


Note: The oil-gas separation filter can only achieve physical filtration, unable to capture the oil vapors in compressed gas; the above outlet oil content refers to the content of the non-gaseous oil aerosols. To get higher quality compressed air, after-filter is required.


Service life

Filter life consumption mainly shows in the form of the flow resistance increasing, so the service life is the primarily related to oil cleanness and filter properties. As long as the system is functioning properly, the service life can be up to 8000 hours(365 days no shut down), but no more than 10000 hours, the glass fiber falling down into the lubrication system causing secondary pollution should be prevented.



Flow Resistance

Flow resistance is an important indicator of filter performance. Under the premise of guaranteed filtration performance, lower flow resistance can reduce compressor energy consumption. Through several tests and improvement, the initial oil saturation pressure drop of oil-gas separation filter is within 16kpa, lower than the standard value 20kpa of peers.


Product Categories : Oil-Gas Separator > Compressor Filter

Product Images

  • Compressor Oil-Gas Separator For Comprag
Email to this supplier
  • *Subject:
  • *Messages:
    Your message must be between 20-8000 characters