Model No.: SD01120250
Brand: Shengda
Clapboard: without Clapboard
Filter Number: 1
Medium Material: Fiberglass
Filtration Grade: ULPA Filter
Type: Cartridge Filter
Packaging: Wooden Case
Productivity: 100 Thousands Annual
Transportation: Ocean,Land,Air
Place of Origin: Xinxiang
Supply Ability: 100 Thousands Annual
Certificate: ISO 9001, ISO 14001, ASME, OHS
HS Code: 8421299090
Port: Qingdao,Tianjin
Payment Type: T/T
Incoterm: FOB,CFR,CIF,FCA,CPT
PN: SD01120250
Flow m³/min/0.7MPa: 12
Flange Diameter: 328
Height: 250
The Oil-Gas Separator is made of different layers. The first layer is usually a coalescence layer, which is made of glass fibers with certain thickness and pore. The multi-layer sub-micron glass fibers ensure high efficiency of micro oil droplets of different lubricants at higher temperatures. The second layer is the separation layer. After coalescence, the large oil droplets flow through the separation layer into the bottom.
Installation:
Install sealing correctly and check whether there is a conductive measure;
Return pipe must be long enough and put straight into the filter, the end should be beveled, pay attention to check blockage;
Use high-quality Air Filter, Oil Filter and coolant and prevent generation of impurities in hydraulic system.
Troubleshooting
I. the high oil content of the exhaust.
1. Return line blockage.
2. Gaskets used improperly resulting in oil core short circuit.
3. Oil Separator tank design or selection unreasonable.
4. Oil barrel oil level is too high.
5. Compressor Low pressure operation, the displacement increases, reduced Separation Filter.
6. Operating temperature is too high, increase the amount of lubricating oil evaporation.
7. Use of substandard lubricants.
Separation Efficiency
Under the rated flow rate and working pressure, outlet oil content: 0.1-3 mg/m³.
Note: The oil-gas separation filter can only achieve physical filtration, unable to capture the oil vapors in compressed gas; the above outlet oil content refers to the content of the non-gaseous oil aerosols. To get higher quality compressed air, after-filter is required.
Service life
Filter life consumption mainly shows in the form of the flow resistance increasing, so the service life is the primarily related to oil cleanness and filter properties. As long as the system is functioning properly, the service life can be up to 8000 hours(365 days no shut down), but no more than 10000 hours, the glass fiber falling down into the lubrication system causing secondary pollution should be prevented.
Flow Resistance
Flow resistance is an important indicator of filter performance. Under the premise of guaranteed filtration performance, lower flow resistance can reduce compressor energy consumption. Through several tests and improvement, the initial oil saturation pressure drop of oil-gas separation filter is within 16kpa, lower than the standard value 20kpa of peers.
Product Categories : Oil-Gas Separator > Compressor Filter