Compressor Oil-Gas Separator For Ingersoll Rand

PN: SD01055180
Flow m³/min/0.7MPa: 5.5

Flange Fiameter: 200
Height: 180

Depending on the design, the Oil-Gas Separator can be composed of different layers. The first layer is usually a coalesced layer made of borosilicate glass fiber with a certain and porosity thickness. The multi-layer sub-micron glass fiber ensures efficient capture of oil droplets of different lubricating oils at higher temperatures. The second layer is a separation layer, and the large oil droplets after coalescence flow through the separation layer into the bottom groove.

If pre-separation of the oil filtration barrel is poor, the pre-Separation Filter layer is added to the outermost layer to prevent the coalescence layer overload and prolong life.

According to the requirements of the chemical industry and commerce association, the metal parts with oil and gas separation filter of the compressor has conductive connection, in order to reliably conducting static load. The appropriate sealing gaskets are selected ensuring a conductive connection to the compressor body.

Separation Efficiency

Under the rated flow rate and working pressure, outlet oil content: 0.1-3 mg/m³.

Note: The oil-gas separation filter can only achieve physical filtration, unable to capture the oil vapors in compressed gas; the above outlet oil content refers to the content of the non-gaseous oil aerosols. To get higher quality compressed air, after-filter is required.

Service life

Filter life consumption mainly shows in the form of the flow resistance increasing, so the service life is the primarily related to oil cleanness and filter properties. As long as the system is functioning properly, the service life can be up to 8000 hours(365 days no shut down), but no more than 10000 hours, the glass fiber falling down into the lubrication system causing secondary pollution should be prevented.

Flow Resistance

Flow resistance is an important indicator of filter performance. Under the premise of guaranteed filtration performance, lower flow resistance can reduce compressor energy consumption. Through several tests and improvement, the initial oil saturation pressure drop of oil-gas separation filter is within 16kpa, lower than the standard value 20kpa of peers.

Product Categories : Oil-Gas Separator > Compressor Filter